Try to loosen the top tension first. If this doesn't work remove the bobbin and tighten the bobbin. Husqvarna Emerald 116 Manual DownloadThe purpose of this is to have the top and bottom tension even. This is similar to a tug of war. Whichever way is stronger is where the knot will be going. You want the knot in the middle of the fabric. Test your top tension by leaving the foot up. Pull the thread through back and forth. Sdac delphi 7 rapidshare download. It should be easy. If it isn't you will need to adjust the tension mechanism. There is a tension set document added to help you.| Answered on May 20, 2015. Check the upper tension by lowering the presser foot and pulling on the thread through the needle. You should feel resistance. If not, take a stiff brush and clean out the tension disks/dials removing any loose threads or lint. If upper tension is ok, check bobbin tension by pulling thread through needle plate opening. You should feel resistance. If not, remove bobbin case and brush any loose threads or lint from the case, especially in the tension spring where the thread is snapped into place. You may need to use a sharp needle to dig in between the spring but be careful that you don't damage it.| Answered on May 10, 2015. Here is a recent answer of mine on the same question:: Q: Why isn't the Needle Thread picking up the Bobbin Thread? A: Steps to Resolve: Take all of theses these steps before trying to pickup the Bobbin Thread again. Check to be sure the needle is properly installed and threaded. A13 allwinner firmware. Check if the Bobbin and Bobbin thread is properly installed. Remove any thread tangle or lint from under the needle plate.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |